return line

英 [rɪˈtɜːn laɪn] 美 [rɪˈtɜːrn laɪn]

网络  返回线; 回线; 回流线; 回扫线; 返回线路

化学



双语例句

  1. Both nodes should return to the command line after the reporting link operates normally.
    在正常情况下,报告链接操作之后,两个节点应该会返回到命令行。
  2. Inside each script, capture the return code of each line command
    在每个脚本内,捕获每个行命令的返回码
  3. In a endElement() event, it would return the line of the end tag.
    在endElement()事件中,它将返回结束标记所在的行。
  4. It is possible to use simple delimiting strategies such as separation by Linefeed ( LF), End of Line ( EOL), Carriage Return, Line Feed ( CRLF), Fixed Length, Whole-file or User-defined.
    可以使用简单的分隔策略,如按换行(LF)、行尾(EOL)、回车换行(CRLF)、固定长度、整个文件或用户定义的方式进行分隔。
  5. Hydraulic reservoir at atmospheric pressure, with return line below fluid level and air filter.
    带有回流管和空气过滤器的液压容器。
  6. Removing and installing oil return line.
    拆卸和安装机油回油管。
  7. Carefully attach the upper part of the oil return line to the lower part of the oil return line.
    小心将机油回油管上部连接到机油回油管下部。
  8. You should see that the blue line is better than the pink line because, for any expected return, the blue line is to the left of the pink line, right?
    可以看到蓝线比粉线好,原因是对于任意的预期收益率,蓝线都在粉线的左边,对吧?
  9. Install valve on return line of equipment to be balanced or as shown on the plans.
    将阀门安装在需要平衡的设备回流管线上或计划要求的地方。
  10. Fit the return line at the reservoir.
    安装储液罐上的回流管路。
  11. If a vapour return line is connected, have operation parameters been agreed?
    如果蒸发气回流管已接通,有关操作参数是否已经协议?
  12. Field may not contain carriage return, line feed or tab characters
    域不能包含回车、换行和制表符等字符
  13. Unclip fuel return line from the line holder on the body.
    从车身上的管路保持架上松开燃油回油管。
  14. As a precaution, the fuel return hose and fuel line of the affected vehicles will be exchanged with a technically modified version.
    检查召回车辆,更换经技术改进的燃油回油管和燃油管路,以作为一项预防措施。
  15. Only then it is ensured that the return line is also completely rinsed out.
    这可确保回流管也完全没有气泡。
  16. Has a vapour return line been connected?
    蒸发气回流管是否已接通?
  17. Position union nut for oil return line on the fuel tank and tighten it.
    将机油回油管的联管螺母放置在燃油箱上并将其拧紧。
  18. Only pressure-less return of the operating medium through return line T2 to the tank, ensures proper work of the I/ H converter.
    只有当工作介质经返回管线T2减压后返回至箱内方可确保I/H转换器正常工作。
  19. An order to return to the base line, i.e.the old Bulgarian border, came.
    然后命令撤回战前的苏保边界的命令下达了。
  20. Then get the other person to fit the grommet for the return line.
    然后让另一人安装回油管的密封圈。
  21. Release the oil return line on the oil-filter console.
    拆下机油滤清器控制壳上的机油回油管。
  22. What be the gross return on this line?
    这比生意的毛利是多少呢?
  23. A Mathematical Model for Mechanic and Hydraulic Servo-mechanism with Negative Lap spool and Orifice in Return Line
    具有回油节流、正开口滑阀的机液伺服机构的数学模型
  24. Using breakdown cases to analyze the modification of power supply circuit, it is suggested that the arrangement of traction return line be combined with the design of signal.
    通过故障案例,分析供电线路的修改,并提出电力部门对牵引回流线的布置应与信号设计组合。
  25. The built-up and every module function of the software, the establishment of double logarithmic coordinate and the drawing of the return line are mainly presented. An example for its application is given.
    文中主要介绍了软件的组成与各模块功用,双对数坐标的建立,回归线的绘制,并给出了应用实例。
  26. In this paper, a new method which is effective on linearizing a complicated automatic control system is used to establish a mathematical model for mechanic and hydraulic servo-mechanism with negative lap spool and orifice in return line.
    本文采用了一种对复杂的自动控制系统线性化行之有效的新方法,建立了具有回流节油、正开口滑阀的机液伺服机构的数学模型。
  27. The research results show that pressure steel-belt CVT has a big potential for reducing fuel consumption through some measures such as slip control, improvement on hydraulic return line, separating clutch or start-stop control etc;
    根据研究结果指出,通过采取诸如滑移控制、改进的液压回路、分离离合器或启动-停止控制等措施,压力钢带式CVT仍具有较大的降低油耗的潜力;
  28. Pressure surge in return line of closed circuit hydraulic system Meanwhile, some other unloading circuits and damping measures are experimentally investigated, leading to methods of reducing the unloading pressure surge.
    同时,文章还对一些其它卸荷回路及其缓冲措施进行试验研究,提出解决系统卸荷压力冲击的具体方法。
  29. A Loading Device for Double-return-line Hydraulics
    液压双回路加载装置
  30. The improvement on supply and return steam line for hot press
    热压机供回汽系统改进